Type S BOV

[BKs50trimGST]

When I installed my new Intercooler I ran into a few problems. My Greddy Type S Bov was not holding boost. So I then replaced it with a 1g crushed BOV, now my question is... can i fix this BOV and with what size spring? I was told I can only buy RS springs for this now, this will most likely go into my 1g AWD project. Any recommendations for the spring i should order? I looked on the Greddy site and i seriously have no idea what spring would be good.

[Pushit2.0]

The type s should have not problem holding any amount of boost if its properly hooked up, and did you do a boost leak test to find this problem?

~John

[x-pride]

Did you adjust the Greddy BOV? You know it is adjustable right!

[mdost03]

Did you adjust the Greddy BOV? You know it is adjustable right!

X2 I always thought the Type S could hold boost up to 25-30 psi without leaking?

[Shane@DBPerformance]

Is it a real Greddy Type-S or an eBay Greddy Type-S?

[x-pride]

X2 I always thought the Type S could hold boost up to 25-30 psi without leaking?

Yes, it can hold 25-30 psi but it is adjustable.

[BKs50trimGST]

it's a greddy type-s and we used a vacuum pressure tester, when we pumped air into it the pressure didn't hold, it decreased pretty quick, we adjusted it and nothing seemed to work, so then i just crushed my 1g BOV off my non-running dsm and threw that on.

[mdost03]

Are both of the springs still in the BOV? Sometimes people will take out the bigger spring inside of them if they are running lower boost levels.

[TkrPerformance]

you more than likely have a riped difram in the bov

[BKs50trimGST]

i'll have to tear apart the bov tomrrow and take a look.