AWD to FWD conversion 5spd

[Pimpin Dsmstyle]

okay what axles do you have currently?

I have both :P I have a set for a FWD and AWD. I have 2 cars and only 1AWD tranny and 1FWD tranny. Make some sense now? :X The one thing I don't have is the adapter peice to use the AWD axles in a fwd tranny. That'd be nice.

[Super Bleeder!!]

Also, FWD axles work with an AWD Trans? If so, upsides? Downsides?

They only work if you dont have a transfer case, otherwise the inner CV joint would interfere with that.

Fwd axles would be a downgrade though, as the awd drivers side axle is a 2piece design with a rigidly supported section that should take out a lot of torque steer.

[ExTREME]

^Oh, Ok Thanks! I was wondering if I missed something somewhere along the line of searching miscellaneous shit about drivetrains in these. i still need to find some new axles..

I still dont get why you're doing this. Nice nade though!

[Super Bleeder!!]

The one thing I don't have is the adapter peice to use the AWD axles in a fwd tranny.

what piece would that be?

[TkrPerformance]

ok on the talon
I have awd axles works just fine with the fwd
starter plat for the awd will work just have to cut the top of the loop off were the starter is that is what is in the talon sence I only had awd plates

[Pimpin Dsmstyle]

what piece would that be?

Starter plate. I'll probably just stick to an AWD tranny in the new car but then I only have 1 running car.

[Pushit2.0]

Put in the FWD tranny, just drop the prop shaft and leave the rest of the rear end in the car, then use the FWD axels and spacer plate/ starter/ flywheel, and make sure you match the shifter cables/base/shifter arms year for year.

~John