Log in

View Full Version : Parting Out 2G

Pages : 1 2 [3] 4 5 6 7
mike55112
03-24-2007, 01:17 PM
I also have a 95 eprom ecu.
bob123131
03-25-2007, 01:33 AM
hey i cna meet you and pay 225 tomorrow for ic and piping which is a good deal considering they go for 250 shipped.
bob123131
03-25-2007, 01:34 AM
Also on a side not im 99 percent sure a type s wil not fit the ic piping without drilling and tapping new holes closer together. They are set up with a 1g flange.
silow_gsx
03-25-2007, 02:18 PM
Mike, I'm interested in the longblock. You're PMs are full. Let me know how much you want for it.
blageo23
03-25-2007, 04:44 PM
His PMs SUCK! he can only get like 25 PMs.
You guys can PM me also, I am helping him part this car out.
mike55112
03-25-2007, 10:10 PM
eprom-sold
fmic-sold
2gmaf-sold
9guy9
03-25-2007, 10:37 PM
how are the 3 interior pannels in the hatch/trunk?

Do you still have the drive shaft?
blageo23
03-25-2007, 11:00 PM
Tranny, Tcase, Driveshaft, Rear End, Gas Tank, Rear Subframe, Rear Axles, Ebrake Cables, Starter, Front CV Shafts... SOLD
eclipse97gs-t
03-25-2007, 11:12 PM
Do you have the center console, AC controls, and trim around the AC controls?
blageo23
03-25-2007, 11:46 PM
Do you have the center console, AC controls, and trim around the AC controls?

$80
Based on a completed Item on ebay(http://cgi.ebay.com/ebaymotors/MISUBISHI-ECLIPSE-center-console_W0QQcmdZViewItemQQcategoryZ33695QQitemZ290 095874244QQrdZ1QQsspagenameZWDVW)