what to replace?

[GUY]

ok i have a 95' eclpise FWD with some small mods and i need to replace the clutch, i was wondering if anyone else had problems after they got a new clutch in that i should replace while the tranny's down? bushings, throw out bearing, clutch fork etc....

[Kracka]

Always replace the throw-out bearing with a Mitsu bearing when replacing the clutch. You should of course also machine the flywheel and replace the tranny fluid with a good performance fluid. Otherwise, replace anything else that looks worn.

[GUY]

what kind of oil would you suggest with some wearing on the 3rd gear syncro?

[Shane55113]

amsoil syncromesh

[Kracka]

Redline MT-90/MTL blend.

[gofastman]

I would shim the pivot ball the clutch for moves on with a washer, raise it about 1mm, a lock washer works well.
make sure the clutch is properly adjusted, if it doesnt disengage fully it will place alot of extra where on your already shitty synchros, and make the tranny grind