Where to get a crank kit for a 2g

[bmikkalson]

Hi, long time lurker first time poster.
Any event I have a stock 2g DSM that one 0f the rod bearings spun on the crank. Any ideas on where to get a crank kit? or would it it advisable to just put a new short block in? Thanks

[EclipseGST]

It would be better to put a 6 bolt motor in it. (90-92.5 motor) If you fix the stock 2g motor, you'll never know if it is going to do the same thing down the road.

[Gravy]

I bleive it's almost a guarantee it will "Walk" again. It's just a matter of when, and how long. Do the extra work needed to swap in a 1g turbo. Look for a 6 bolt, and don't bother installing a 7 bolt.

You can find instructions on VFaq.com.

[EclipseGST]

Hi, long time lurker first time poster.
Any event I have a stock 2g DSM that one 0f the rod bearings spun on the crank. Any ideas on where to get a crank kit? or would it it advisable to just put a new short block in? Thanks

After re-reading your post, I'm guessing this car is a 2g turbo? If it isnt, forget what I said.

[bmikkalson]

This car is just my daily driver, And I may even sell it after I get it fixed.

[1QUICK4]

Crankshaft supply will have what your looking for.

[Goat Blower]

A rod bearing failure is not crankwalk boyz.

If you're endplay is fine, just have the crank turned and put in the .010 under bearings to go with it.

[Shotgun!]

Goat Blower FTW!

[EclipseGST]

A rod bearing failure is not crankwalk boyz.

If you're endplay is fine, just have the crank turned and put in the .010 under bearings to go with it.

Your still messing with the thrust bearing. Just like playin with the devil. :p

I never said it was crankwalk. Just greater chances of getting if you screw with it. ;)

[bmikkalson]

Thanks guys, I will give Crank shaft supply a call in the AM