14b install?

[Shane55113]

The hardest part i had was taking off the lower far drivers side manifold bolt, that thing was a bitch, i finally got it buy getting a 1/4 inch 14mm and putting the socket on 1st then fandangeling the wrench into the socket hole. This was on a 1g 6 bolt with power steering (p.s. bracket in the way) I'm not putting a bolt back on it.

[98gstaherns]

got ya Thanks!

[98gstaherns]

With a j pipe can I put a 90 degree coupler on it to make it work with a FMIC?

[blageo23]

Do you have an install kit? If not you are gonna need the oil feed and return from a 1G. The 2G oil feed will not work with a 14B(I have tried).

[98gstaherns]

Oh yea i got that install kit..Because I'm a pimp like that!
Also I got Turbo manifold bolts, coolant,wd40,pb balster,Oil, Oil filter, turbo..Blah i hope this goes good.

[s1ngletracker]

dude, its easy, just be careful when threading and unthreading the oil feed supply line bolt.

[98gstaherns]

Ok cool thanks!

[Tauni]

dude, its easy, just be careful when threading and unthreading the oil feed supply line bolt.

Very good advice.

[98gstaherns]

So anyone wanna help out at all? I don't wanna mess this up and not have a car running..

[s1ngletracker]

Not to make you feel stupid or anything, but tauni pretty much did this on her own. JK.

but seriously, if you need help, i'm back on weds night of next week. You're more than welcome to come over and we can get your turbo swapped.