SchuttsR1
03-17-2006, 01:01 AM
I have a sanota block looking for a purpos, and have a few questions.
1. Could I use the 1st gen stock pistons? And what rings would I need to seal it up. Also what compression would that yeild. If not were can I get a set of pistons to work. Kinda want to keep the stock rods.
2. If I can use the stock pistons would ceramic coating them help with longevity? I am from the wonderful world of Rotaries and when you ceramic coat the face of the rotors it cuts down on heat damage to the rotors.
3. Does any one have a part number for the stubby shaft and the spacer for the crank to elimanate the b shafts?
Going to shot for 450whp on the stroker with a 20g.
Thanks
1. Could I use the 1st gen stock pistons? And what rings would I need to seal it up. Also what compression would that yeild. If not were can I get a set of pistons to work. Kinda want to keep the stock rods.
2. If I can use the stock pistons would ceramic coating them help with longevity? I am from the wonderful world of Rotaries and when you ceramic coat the face of the rotors it cuts down on heat damage to the rotors.
3. Does any one have a part number for the stubby shaft and the spacer for the crank to elimanate the b shafts?
Going to shot for 450whp on the stroker with a 20g.
Thanks