2nd gear grinds need help

[CornFed2.4]

Im replacing my master cylinder and slave cylider cause they r both bad fluid everywhere bled if filled it and now second grinds will this go away after I fix the twoo cylinders????

[GVR-4579]

If your clyinders are bad then it will definatly help, but if the syncro is worn out then its too late and wont do any good you would need new syncros then.

[blageo23]

Try using Pensoil Syncromesh for tranny fluid. Word on the street is it help out with that.

[CornFed2.4]

will do thanks

[CornFed2.4]

ok so I replaced the master and slave cylinder didnt help so now I have a couple of ??? s If i rebuild my tranny does my tranny bolt up to a 6 bolt motor reason I ask is cause im saving to do the motor swap and I dont wanna rebuild my tranny unless I can use it in my swap.. And is the syncromesh is that a gear lube and where ould I buy it.. So if any one has any better suggestions let me know it is a 98 gsx with 72000 miles on it thanks

[EclipseGST]

Yes.. The only thing you will need is a 6 bolt flywheel to allow it to bolt up.

[tim]

Pensoil Synchromesh can be found at most parts stores. GM also makes a Syncromesh that can obviously be bought at the dealerships but it is quite a bit more expensive.

[CornFed2.4]

ok so if I send my tranny to shep theyll rebuild it for $900 stage 1 how much and where could I get it pulled out???

[CornFed2.4]

Yes.. The only thing you will need is a 6 bolt flywheel to allow it to bolt up.

where did you get your six bolt installed

[niterydr]

We are $500 for a clutch job on a 2g awd.